Extreme Networks Summit WM Series Instrukcja Użytkownika Pobierz pdf (Strona 4)

PN: 72-9958-00-A.doc Page 4

Controller Setup

The setup steps described below refer to the network topology diagram shown in this

document. Make sure all the access points are disconnected from the system if

configuring the system for the first time.

Assigning an IP Address to a Wireless Controller

1. Log onto the controller by opening a web browser and connect to

https://192.168.10.1:5825/. The default username is ‘admin’; the default password is

‘abc123’.

2. Navigate to Summit™ Switch and select IP Addresses from the left hand side of the screen.

3. Change the value of esa0 to 192.168.110.10 and 255.255.255.0 for the IP Address and

Subnet mask. Click the checkbox for Mgmt and SLP for this port only (thus turning it

on). Leave them unchecked (off) for the other ports. For Function, select Host Port if

static routing is used. Otherwise, select Dynamic Port if OSPF is being used for routing

and routing advertisements. Enter esa0 for Multicast Support. Refer to the screen shot

shown below.



This is for topologies where the SpectraLink gateway(s) and SVP Servers

are located adjacent to the esa0 port, as was done in this certification test.

In topologies where the setup is different this multicast setting should be

configured to be whichever port the SpectraLink servers are adjacent to.

This setting permits proper wired replication of multicast data from the

wireless subnet.

4. Save the settings using the Save button.

1 2 3 4 5 6 7 8 9 ... 17 18

Brak uwag

Extreme Networks Summit WM Series Instrukcja Użytkownika Strona 4