Extreme Networks Summit WM Series Podręcznik Użytkownika Pobierz pdf (Strona 43)

Installing the Altitude APs

Summit WM-Series WLAN Switch and Altitude Access Point Software Version 1.0 User Guide

Installing the Altitude APs

Install the Altitude APs as described in the Altitude AP Installation Guide packed with the units.

1 Unpack the Altitude AP from its shipment carton. Check that all parts are present, using the

Installation Guide packed with the unit.

2 Mount the Altitude AP wall bracket, using 3 screws, near the LAN ethernet cable plug coming from

the wall.

3 Press the back of the Altitude AP onto the bracket, aligning it with the open notches in the bracket.

Then slide it downwards until it clicks into place.

CAUTION

There should be at least 9 inches (20 cm) separation between the Altitude 350-2 and, or antenna and users.

To remove the Altitude AP, release the spring clip by inserting the Allen key (provided) into the

small hole at the bottom of the bracket. Use the Allen key to depress the spring clip. Then slide the

case up the bracket and lift off the Altitude AP. Keep the Allen key in a safe place.

4 Insert the plastic spreading rivet through the hole at the bottom of the bracket and into the Altitude

AP case. Then screw in the plastic screw. This spreads the rivet and locks the case to the bracket. To

remove the Altitude AP, use a screwdriver to take out the screw.

WARNING!

For installations that use Receive diversity (the default) the antennae should be pointed in the same direction.

For installations that do NOT use Receive diversity or for those that split the 802.11a and 802.11b/g radio onto

different physical ports, then the antennae can be pointed in whatever direction is desired.

AP_top_bottom

Power connector LAN ethernet

port connector

Opening for

Allen key

Opening

for rivet

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 227 228

Brak uwag

Extreme Networks Summit WM Series Podręcznik Użytkownika Strona 43