Extreme Networks WM-4T1i Podręcznik Użytkownika

Przeglądaj online lub pobierz Podręcznik Użytkownika dla Networking Extreme Networks WM-4T1i. Extreme Networks WM-4T1i User guide Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj

Podsumowanie treści

Strona 1 - WAN Module Installation

Extreme Networks, Inc.3585 Monroe StreetSanta Clara, California 95051(888) 257-3000http://www.extremenetworks.comWAN Module Installation and User Guid

Strona 2

1-2 WAN Module Installation and User GuideInstalling the WAN ModuleInstalling the WAN ModuleAll Alpine ™ 3800 series switch module cards (SMMi modules

Strona 3 - Contents

WAN Module Installation and User Guide 1-3Ports and ConnectorsNote: Tighten the screws before inserting additional modules. If you insert additional m

Strona 4 - Index of Commands

1-4 WAN Module Installation and User GuideInstalling the WAN ModuleFigure 1-2: WM-1T3i ModuleThe WM-1T3i module has one T3 port, consisting of a two B

Strona 5 - Introduction

WAN Module Installation and User Guide 1-5Ports and ConnectorsTable 1-1 describes the LED behavior on the WAN modules.The slowly blinking LEDs cycle o

Strona 6 - Conventions

1-6 WAN Module Installation and User GuideInstalling the WAN ModuleInstalling the WAN Module SoftwareOnce the WAN module is installed in the chassis,

Strona 7 - Convention Description

WAN Module Installation and User Guide 1-7Installing the WAN Module SoftwareThe module can store up to two images; a primary and a secondary. When you

Strona 8 - Related Publications

1-8 WAN Module Installation and User GuideInstalling the WAN Module

Strona 9

WAN Module Installation and User Guide 2-12Configuring the WAN Physical LinkThis chapter covers the following topics:• Configuring WAN Physical Links

Strona 10 - Installing the WAN Module

2-2 WAN Module Installation and User GuideConfiguring the WAN Physical LinkRed, Blue, and Yellow AlarmsWAN links have error detection built into the l

Strona 11 - Ports and Connectors

WAN Module Installation and User Guide 2-3Configuring WAN Physical Links• Timeslots (E1)• Yellow Alarms (T1)Cable lengthLonger cable lengths cause gre

Strona 12 - Module LEDs

ii ©2001 Extreme Networks, Inc. All rights reserved. Extreme Networks and BlackDiamond are registered trademarks of Extreme Networks, Inc. in the Unit

Strona 13 - Table 1-1: WAN Module LEDs

2-4 WAN Module Installation and User GuideConfiguring the WAN Physical LinkClock SourceA clock is used to synchronize data transmission on the line. G

Strona 14

WAN Module Installation and User Guide 2-5Configuring WAN Physical Linksconfig ports <portlist> e1 framing [crc4 | no-crc4]The framing choices f

Strona 15

2-6 WAN Module Installation and User GuideConfiguring the WAN Physical Linksend an SNMP alert to the SMMi in the switch when red, yellow, or blue alar

Strona 16

WAN Module Installation and User Guide 2-7Configuring WAN Physical Linksalarm generation and detection is both. To configure yellow alarms, use the fo

Strona 17 - Configuring the WAN Physical

2-8 WAN Module Installation and User GuideConfiguring the WAN Physical LinkMonitoring WAN Physical LinksT1, E1, and T3 devices have a built-in facilit

Strona 18 - Red, Blue, and Yellow Alarms

WAN Module Installation and User Guide 2-9Monitoring WAN Physical Linksto the remote end. At the remote end, the process is reversed as the framing bi

Strona 19 - Cable length

2-10 WAN Module Installation and User GuideConfiguring the WAN Physical LinkLocal Loopback Mode. When the local port is enabled for local loopback, t

Strona 20 - Clock Source

WAN Module Installation and User Guide 2-11Monitoring WAN Physical LinksFar-End Loopback ModesThe far-end of T1 links can be enabled for the following

Strona 21 - SNMP Alerts

2-12 WAN Module Installation and User GuideConfiguring the WAN Physical LinkFigure 2-6: Remote payload loopback modeRemote Payload Loopback Mode. Whe

Strona 22 - Yellow Alarms

WAN Module Installation and User Guide 2-13Monitoring WAN Physical LinksWAN Port Monitoring CommandsTable 2-2 describes the commands used to monitor a

Strona 23

WAN Module Installation and User Guide iiiContentsPrefaceIntroduction -vTerminology -viConventions -viRelated Publications -viii1 Installing the WAN M

Strona 24 - Monitoring WAN Physical Links

2-14 WAN Module Installation and User GuideConfiguring the WAN Physical Link

Strona 25 - Remote WAN PortLocal WAN Port

WAN Module Installation and User Guide 3-13Configuring PPP and MLPPPThis chapter covers the following topics:• Multilink PPP and Multilink Groups on p

Strona 26

3-2 WAN Module Installation and User GuideConfiguring PPP and MLPPPTypically, you would create a multilink group, configure the multilink group by add

Strona 27

WAN Module Installation and User Guide 3-3Configuring a PPP/MLPPP LinkTypically the last step in configuring a multilink group is to use the following

Strona 28 - Disabling Loopback Mode

3-4 WAN Module Installation and User GuideConfiguring PPP and MLPPPconfig ppp authentication [off | chap | pap | chap-pap] [ports <portlist> | m

Strona 29 - WAN Port Monitoring Commands

WAN Module Installation and User Guide 3-5Configuring a PPP/MLPPP LinkRouted packets are transported across a PPP/MLPPP link using IP Control Protocol

Strona 30

3-6 WAN Module Installation and User GuideConfiguring PPP and MLPPPMonitoring PPP/MLPPP LinksThe following commands monitor the status of the PPP and

Strona 31 - Configuring PPP and MLPPP

WAN Module Installation and User Guide 3-7PPP/MLPPP Configuration ExamplesPPP/MLPPP Configuration ExamplesThe following examples show how to configure

Strona 32

3-8 WAN Module Installation and User GuideConfiguring PPP and MLPPPFigure 3-1: BCP multilink examplecreate vlan alphaconfig alpha tag 1001create multi

Strona 33 - Configuring a PPP/MLPPP Link

WAN Module Installation and User Guide 3-9PPP/MLPPP Configuration ExamplesFigure 3-2: IPCP multilink examplecreate vlan betaconfig beta tag 1001config

Strona 34 - Encapsulation

iv WAN Module Installation and User GuideLinecoding 2-5Receiver Gain 2-5SNMP Alerts 2-5Timeslots 2-6Yellow Alarms 2-6WAN Port Configuration Commands 2

Strona 35

3-10 WAN Module Installation and User GuideConfiguring PPP and MLPPP

Strona 36 - Monitoring PPP/MLPPP Links

WAN Module Installation and User Guide A-1ASafety InformationIndustry Canada CertificationThe Industry Canada label identifies certified equipment. Th

Strona 37 - command

A-2 WAN Module Installation and User GuideFCC CertificationThis equipment complies with Part 68 of the FFC rules. On the printed circuit board of this

Strona 38 - Switch #1

iIndexNumerics802.1p 3-4802.1Q 3-4Aalarms 2-2alternate mark inversion (AMI) 2-5AMI linecoding 2-5authentication 3-3BB8ZS linecoding 2-5BCP encapsulati

Strona 39

ii - INDEXT1 port 1-5linecoding 2-5AMI 2-5B8ZS 2-5loopback detection 2-5MM13 T3 line framing 2-5MLPPP 3-1multilink group 3-2adding to VLAN 3-2Multilin

Strona 40

Index of Commands - iIndex of CommandsCconfig multilink add ports 3-5config multilink delete ports 3-5config ports e1 clock source 2-7config ports

Strona 41 - Safety Information

ii - Index of Commandsshow ports e1 info 2-13show ports e1 stats 2-13show ports stats 2-13show ports t1 alarms 2-13show ports t1 configuration 2-

Strona 42 - FCC Certification

WAN Module Installation and User Guide vPrefaceThis Preface provides an overview of this guide, describes guide conventions, and lists other publicati

Strona 43

vi WAN Module Installation and User Guide TerminologyWhen features, functionality, or operation is specific to one of the WAN modules, the specific mo

Strona 44

WAN Module Installation and User Guide viiConventionsWords in italicized type Italics emphasize a point or denote new terms at the place where they ar

Strona 45

viii WAN Module Installation and User Guide Related PublicationsThe publications related to this one are:• ExtremeWare™ release notes• ExtremeWare Sof

Strona 46

WAN Module Installation and User Guide 1-11Installing the WAN ModuleThis chapter covers the following topics:• Installing the WAN Module on page 1-2•

Komentarze do niniejszej Instrukcji

Brak uwag