Extreme Networks WM-4T1i Podręcznik Użytkownika Pobierz pdf (Strona 37)

WAN Module Installation and User Guide 3-7

PPP/MLPPP Configuration Examples

The following examples show how to configure multilink groups.

Configuring a Bridged PPP/MLPPP Link Example

The following example shows how to configure a BCP-encapsulated multilink group.

BCP is the default encapsulation, so it is not explicitly included in this example. While

only one VLAN is shown in this example, you may configure multiple VLANs across

the link. The

config ports t1 clocksource command is included to show where

you might need to configure the T1 parameters for your link. Each T1 port in the

multilink group will have the same T1 and PPP configurations. If you change the

configuration for a single port, the change will affect the entire group.

show ppp {<portlist>} {detail} Shows PPP configurations.

show accounts pppuser Show the PPP accounts on the switch.

1. To display alarm status for T3 links, use the show ports t3 alarms command

2. To display error statistics for T3 links, use the

show ports t3 errors command

Table 3-2: PPP/MLPPP Show Commands (continued)

Command Description

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 45 46

Brak uwag

Extreme Networks WM-4T1i Podręcznik Użytkownika Strona 37